CNG Kit Maintenance
in Zirakpur
Keep your CNG car running smoothly with complete computer tuning, filter replacements, injector ultrasonic cleaning, and gas leak audits by certified engineers.
- Computerized ECU Diagnostics
- Ultrasonic Injector Cleaning
- High-Pressure Gas Sniffer Audit
- 45-Min Express Service
Why Choose Bansal CNG Solutions?
Genuine CNG Kits
We install only 100% genuine and certified CNG kits from trusted brands for maximum safety and performance.
Certified Technicians
Our experienced professionals ensure accurate installation using industry-approved methods.
Safe & Secure Installation
Every installation follows government safety standards for reliable performance.
After-Sales Support
Complete maintenance, technical guidance, and warranty assistance after installation.
Precision Technical Care
Our 6-Point CNG Servicing Modules
Performed by master Italian-certified technicians in Zirakpur and Mohali using high-precision scanner diagnostics.
High & Low Pressure Filter Replacement
Dual filter replacement (liquid phase and gas phase). Prevents microscopic compressor oil and rust particles from clogging your gas injectors.
Ultrasonic Injector Cleaning & Calibration
Injectors are demounted and cleaned in an ultrasonic bath followed by flow-rate pulse testing. Eliminates engine jerking during acceleration.
Reducer / Vaporizer Overhaul
Complete pressure regulator cleaning, rubber diaphragm inspection, oil purging, and 2-stage pressure stabilization adjustment.
Computerized ECU OBD-II Tuning
Real-time air-fuel ratio calibration using OBD-II scanner software. Fine-tunes gas timing to match original petrol engine parameters.
Electronic Leakage Safety Audit
Full high-pressure pipeline and trunk valve inspection using digital gas leak sniffers and soap solution checks up to 200 BAR pressure.
Hydro-Testing & Compliance Certificate
Mandatory 3-year cylinder hydrostatic pressure testing with official government approved compliance plate and paper certification.
CNG Brands We Service & Tune
Frequently Asked Questions
We recommend replacing CNG low/high pressure filters every 10,000 KM along with ECU software tuning. Reducer oil purging and injector pulse testing should be performed every 15,000 to 20,000 KM.
Delayed filter changes allow heavy compressor oils and dust particles to enter the high-precision gas injectors. This leads to severe engine jerking, poor acceleration, bad mileage, and eventual failure of expensive injector rails.
Absolutely! Clean gas filters, ultrasonic-cleaned injectors, and precise OBD-II ECU auto-mapping ensure complete combustion. Car owners typically notice a 15% to 25% improvement in mileage after a full service.
A standard CNG filter replacement and computerized ECU scan takes approximately 45 to 60 minutes. A major service including ultrasonic injector cleaning and reducer overhaul takes around 2 to 3 hours.
